Yep, I would say that either you can't hold the saw PERFECT (no offense, it is H A R D to do!! ) Or the chain/bar is worn. I would bet on the chain and bar being worn.
I have cut through bigger stuff like that before, and the saw will do it better if you can keep in the same track, such as cut is as much as you can, then start rolling the log a little and cutting a little, that way HOPEFULLY the tip of your saw will be in the channel of where you have previously cut!!
We personally have a little Husky with a 22 inch on it, and I think that it is too small, especially for a guy like my self that is 6' 5" tall, I have to bend over a LONG way to get to where I am going!!! I am working on buying a 288 Husky, it will have a 30 inch on it, MUCH better!!
Unless you are tight on space a little bit bigger saw with a little bit bigger bar is MUCH nicer to use!!! Bryce
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
