Posted by robert major on June 19, 2014 at 23:05:53 from (216.81.8.86):
In Reply to: Re: Yep, She Be Shot posted by Fordfarmer on June 19, 2014 at 20:35:10:
Hi I did say usually and that is from my experience of what I have seen. So many tractors have bad operators driving the cr@p out of them, and not following good operating practices these days it can cause failure, I'm not implying that's what this guy did.
Some equipment does'n't have a gauge on just a light. Turbo bearings are very sensitive to oil pressure at the speeds they run at. The light might not pick up the pressure drop that accurately that can cause failure, this could or couldn't be an issue here.
If you got a bad turbo you where unlucky and it could of caused your problem. I personally don't trust these cheap china turbo's and the re builds from some places either these days I don't know what your situation was here. I'm not saying this is what you did either, I have seen guys that should Know better go to fit a turbo without priming it with fresh oil, before fitting, then just fire up the motor with it dry and rev it full bore!. Or standing there spinning it with there hands with no oil in before fitting!. They don't deal with that very well either in some cases. I figured I would just point out something relevant I had seen before. Because you never know with some of these problems that crop up on machines and the causes. A guy can very easily over look something important sometimes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
