Posted by jon f mn on June 24, 2014 at 10:49:48 from (70.194.140.96):
In Reply to: welding posted by wbond on June 24, 2014 at 07:31:55:
Get a torch first. They are about the most important of the welding tools. heating to loosen parts and cutting steel are the most common things done, at least for me. You can also braze light steel and cast iron and gas weld steel. But you have to be careful what you buy, especially at auctions. most tanks are leased and are worthless if bought at an auction. No gas company will fill lease tanks from another company and if you try to fill leased tanks without the paperwork the gas company will just take them from you. If they claim the tanks are owned make sure you get the paperwork that goes with them.
As far as welders goes, the advice given so far is all good. You have to decide where your priorities are. From what you have said so far I would recomend a small wirefeed, but in 220 volt. The 110 volt wire feeds are only good for about 1/8", maybe 3/16" if you get a good one, and they loose a lot of power if you try to run them from an extension cord. The 220 volt models will weld up to 1/4" well, and there is surprisingly little welding on the farm that is thicker than that, and for that you can weld multiple passes to get by for most of it. I've tried out all the brands and in the small migs the Lincoln is by far the best. And the ones sold at the discount stores are not the same as those sold at most welding supply stores and are cheaper for a reason.
There is nothing wrong with getting a stick welder also, they are cheaper to start with and can do more stuff, but are a bit harder to use than mig welder.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
