Posted by fredvoth on June 26, 2014 at 20:21:35 from (70.195.7.136):
I have a white 125 workhorse tractor with two gauges, temp and fuel not working.
I have power to all gauges and when I ground the sending wire the gauges peg out to the right. I have power to both the temp sensor and fuel connection ie float, but not sure of voltage.
the power to the gauges starts with voltage gauge and it works fine, then it moves on to fuel temp and oil p. I have traced the grounds down and that doesn't seem to be the issue.
i have traced the sending wire to the plug just in front of the cab, when I ground the fuel & temp at the plug I get slight movement on the gauge, but it doesn't peg out and it does the same thing at the temp. sensor.
Does anyone have any advice on what else I can do/check?
This post was edited by fredvoth at 20:26:17 06/26/14 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
