Posted by CAS on June 28, 2014 at 13:56:48 from (67.240.133.144):
In Reply to: Shop floor concrete posted by UP Oliver on June 28, 2014 at 13:10:16:
Seven years ago I poured my shop floor in 2 sections. They were 40X50 fr. In the shop section I put the box wire and pex tube in the floor. Concrete was a 4000 lb mix and 6 inches thick. In the storage section used the box wire, 4000 lb mix and 4 inches thick. It was in 2 pours and the only joint is between the 2 slabs. Sealed the concrete the day after pour. There are no cracks in the floor and the heaviest machine I drive on it fairly often weighs about 24,500 lbs. I think the most important things I did were putting 3 foot of gravel in one year before and letting it settle over winter. Second thing was tamping with a little vibrating packer you push around by hand after leveling the base. Everybody talks about rebar, fiber in the cement, and thickness. Over the years we have poured quite a bit of cement. The best and longest lasting were where extra time and thought was given to drainage and a firm base. Doing those two things in my mind will do more than anything else. One other thing I did was put about 2 inches of #1 stone under all of the cement.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.