[quote="Goose"](quoted from post at 10:55:52 07/02/14)......I understand there are regulations that cover the horn........[quote="Goose"]
Yes there are, but over the past 8 years we have lived by the rail line we have heard many variations on the "regulation" horn usage.
We always joke that some of the engineers had grown up as little boys always wanting to drive a real train, so those guys you can hear for many miles away,,,,,, They really lay on the horn at every crossing. ( we have 4 crossings within a mile of the house one with gates and 3 private crossings) Sometimes a train passes through with just one short blip on the horn at each crossing, it really depends on the engineer.
Last month we even had one play " shave & haircut ,two bits" as he went past. ( probably a cute girl up on the road!) i was raking on a tractor when I heard it, dam near lost the line I was raking laughing about it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
