Posted by randallinMo on July 08, 2014 at 06:20:51 from (216.74.205.155):
In Reply to: Square baling hay. posted by IaGary on July 08, 2014 at 06:00:47:
Your story sure brings back memories to me. My brother and I did the same thing for all our neighbors when we were that age as well. I would have been about 11 years old and my brother 12. We started out making 1 cent per bale. We would work all day long....the heat never seemed to bother us. We finally graduated up to 1 1/2 cents per bale. Some days he and I would ride our bikes home with 10-12 dollars in our pocket. We probably averaged $7 per day. Dang.........we had more money than we knew what to do with! When I turned 14, one of our neighbors hired me as their full time hired hand in the summer working on their dairy. He and his wife would take a 10 day vacation every summer and leave me there to take care of their entire dairy. 'Quite a responsibility for a 14-15 year old kid. He still shipped milk in milk cans to the creamery. I had to haul the milk cans to town as well. I drove his old Chevy pickup the 6 miles into town (no drivers license)and delivered the milk. I thought I was pretty big stuff doing that! "BIG MEDICINE" for a 15 year old! I remember those days just like it was yesterday. I had an accident one summer with his old Chevy pickup. I was driving down this grade on a gravel road and the brakes went out. 'Absolutely no brakes. There was a 90 degree curve at the bottom of the hill. I made the curve but took out the neighbors fence. That was one scary ride. I walked to the mans house and told him I had run through his fence. He replied "probably driving too fast weren't you"......I said "no sir, the brakes went out on the pickup". When we went back to retrieve the truck and fix the fence he acknowledged "young man, you told me the truth about the truck". That made me feel good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
