Posted by ASEguy on July 17, 2014 at 04:52:01 from (24.207.176.4):
In Reply to: engine honing posted by Nick167 on July 16, 2014 at 19:01:02:
Honing is not just to provide sufficient oil for ring break-in, but also to allow for proper piston to bore clearance. If the bore and piston are new then you will need to have that clearance verified. I would check that clearance anytime I replace either the piston or the sleeve.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Collection of Farmall Stories - by Various Authors. We receive quite a few short stories from our readers, and we appreciate every one. Presented here is a collection of two Farmall tractor stories for your enjoyment. [Editor] Memories of Dad's Farmall A J.Brandt My father first started farming with a Farmall A that he purchased in 1940. It was used on a large grain farm in North Dakota where I still live close to but do not farm. There are many memories of this tractor mowing hay and cultiv
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
