As you can see, there are many opinions on this, many different ways. ;)
Mix the glyphosate on the heavy side of the label, and should be fine without. Most glyphosate has some form of surfactant in the jug already. What is the brand name of yours, we can look up the label? Sometimes the wrong 'crop oil' (there are three different types...) can argue with what is already in the jug and make things worse in the end....
What does help glyphosate a lot is some form of N in the water, only takes a little. AMS is granular like sugar, 40lb bag treats 300 gallon tank of spray. There are liquid versions too, many different names. It helps soften your water, glyphosate doesn't work well in hard water, and it helps the weeds grow a tad so they die better, is why you want to add some.
I have heard of others mixing 24D with glyphosate, but it used to be that didnt work - one kills the green part real fast, and the other kills the plant real slow by moving down to the root first. They would cancel each other out and not work near as good as either by the self. But, it must work as a lot do that.
It's been done every which way, it will work out for you however you try it.
I'd try to find a little AMS or liquid N to add, that does help condition the water so it all works better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
