Posted by jennifer408 on July 26, 2014 at 11:50:55 from (67.142.162.25):
well, we finally got the old 10k generator back up and running thanks to the good knowledge of the kind folks here on YTC. first i told the old man to put some ATF in the cylinders and let it sit for a few days and in the mean time i told him to boil the carburetor in some soapy water for a few hours. the fuel pump was leaking and we ordered a rebuild kit for it but after 2 weeks they emailed us and said they couldn't get it any more (story of our lives) so we ordered a new one. we fired it up and it would run good for awhile and then start freaking out, sputtering and all so we started going thru the electrical, he took off the coils for the mag and sanded them clean and wa-la it was is running like a top. whew !!! finally !!!
anyway, i haven't stick welded anything for about 35 years, im using up some old welding rods that don't have all of the flux still on them, but what do you think, am i hired ? :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
