Posted by Frank 41 on July 28, 2014 at 18:14:13 from (50.122.40.148):
In Reply to: Moving a grain bin posted by Tramway guy on July 27, 2014 at 18:36:31:
I had my neighbor move three 18' bins and he set them on pads I poured for them. He had two pipes with a tire on each side with cross braces curved so it would fit the bin. The back end had wide runners that were curved. The front had a hitch. The truck was about 20' long so it would cradle a bin. He would take a loader to pick the up and place it against the bin, then cable it to the truck and place a X brace inside. Take his loader and pull it over. Hook it up to his tractor and down the road he would go. When he came to a ground electrial wire, he would put a board on top of the bin so it would not catch the bolts. He had it made so the roof did not hit the pipes, maybe he had it doubled piped. But he only used it for 18' bins. He moved a lot of government bins. I have seen helicopters move them also.
I think I would take the insurance money and down the road I would go. Either buy a larger bin or none at all.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
