Posted by Billy NY on August 04, 2014 at 07:24:15 from (66.67.105.23):
In Reply to: Efficiancy of Labor posted by fergienewbee on August 04, 2014 at 06:42:54:
There are so many different ways, and situations, the bottom line is less handling, its still labor but anywhere you can eliminate a step, not work off the ground and or put a lot of strain or work on your back, makes it much easier more tolerable.
I'll bet its a wash, takes 2x the time to load that truck tightly packed and to unload, vs, small loads, multiple trips, which may burn a little more fuel.
Where I live, the main road, a state road, opens up to a 4 lane road, leading into the nearby city and interstate highway system. On the return trip home, where it changes back to 2 lanes, it backs up to a standstill with local and a lot of non local traffic heading into Vermont.
The section of road from the 2 lane where it changes to the bridge connected to the highway is loaded with traffic lights, and intersections and somewhere on this stretch, all the way up to the change to 2 lanes I can spot a tractor trailer, a truck or anything large enough to see again and remember by the name on it, or whatever it is. I will use an alternate route to go around, its longer, but I don't sit, and there have been many many times where I get to my lane, where I turn off the state road, and meet that vehicle I bookmarked in my head, exactly sometimes, so its a wash, I keep moving, but its longer distance, they keep moving slower, but shorter distance, funny how that works, it still seems faster with the longer router because you are not sitting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
