Posted by Ron-MO on August 16, 2014 at 08:39:43 from (174.131.234.127):
In Reply to: outdoor wood furnace posted by WV 2cyl on August 16, 2014 at 05:32:06:
I purchased the furnace in the link (actually changed some since then), in 2008. I had looked hard at the Hardy, but was told by someone that had ran both that the Heatmaster used far less wood than a Hardy. I disagree with those that burn green wood, as I was told the same and did so for the first few years until I learned better. I now only cut dead wood, or let it dry well, and I probably use half the wood I did when I put green in it. I also heat my hot water. I can agree that if you do not like cutting wood, going outdoors in all sorts of weather, you would not enjoy one. I am all in it for the cost savings, or I would not own one, but this furnace saves me a LOT of $$ over the course of a year. I figure it paid for itself in 5 years, and I have had very little problems with it so far - other than a door gasket which I purchased locally and made myself. Not sure how well I will like it as I get older, but I can always install something else when the time comes. Wife does enjoy the endless supply of very hot water that it provides which is a side benefit. Geothermal would definitely not help with the hot water my wife likes to use during the winter months. One thing I can comment on is that I still do not buy into those that say they can refuel only once a day - maybe on a sunny 50 degree day, but when it is cloudy, and stays below freezing during the day, I have to put wood in at least twice, and usually a third time. My normal day is check/fill when I get up, again when I get home from work, then again before going to bed. Keep in mind, depending on the weather, I may not have to refuel or add much during those checks, but get in the habit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
