That does NOT work on that plow. The small frame is 11" measured like that and is 10" or 12", the medium is 13" and 12" or 14" and large is 15" and 14" or 16". The vertical part of the beam has a bend in and to change furrow width you take that piece from the back bottom and move it to the front and front to back, that is where you get 2 furrow width sizes per frame from. And Deere used the same moldboards for the 10", 12" and 14" bottoms, just differend length shares. I had a 12" plow but it was the 55 3 furrow and the part numbers are all the same for all three bottom sizes, Last time I bought new shares and this was for a medium frame 44 (was a different bottom than the 55) and se on 14" I ordered 14" shares and got the 10" as that was all Deere still had. Part numbers is the only way to tell what parts he has. The 44 was Deere's only size adjustable 2 bottom plow and they made a 3 bottom that adjusted simular but those are very scarce, never seen one in my almost 71 years. Think the number was 56.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
