Price on steel here is no osb, just purlins. Labour on shingles cheaper because everyone and dog competing to install. Labour on steel cheaper because I don't mind doing steel on low pitch and its fast.
The truss pricing I got back most recently on a 30x60 ranged from 1800 to just under 3200$ depending on pitch, overhang and spacing. The contractors told me they would only erect 32" or less spacing trusses as it is a pain working on the wider ones to reach the next one. The wider spacing is cheaper and I could assemble them on the ground.
My CCA treated pole quote for 18 ft poles was 60$ per pole.
Wall purlins I can cut on my own mill, the building inspector will let them go ungraded.
I can also cut all the poles I want on my own property or I can swap them about 3-1 to get CCA poles back from Marwood the treatment place based on their current buying prices.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
