If two generator are connected 180 degrees out of phase. That will be at a minimum a bad sound and opened protective devices. Twisted off shafts, stator windings shifted and contactor/circuit breaker explosions possible.
Canada way back when just like every other country experimented with 25, 33-1/3, 40,50 & 60 cycle power in the late 1800's and early 1900's.
Early in the 1900's the standard was 25 cycle as most of Ontario's and other provinces power was generated by Hydro Electric. By 1955-1957 the standard was 60Hz across all of Canada. With a few odd pockets of 25Hz. Until approx 10yrs ago Beck 1 at Niagara. They still made 25Hz to supply the Hamilton Steel mill's motor generator sets to run the DC motors on the rolling mills to hot forge steel to shape.
Voltages are 120/240 single phase. 120/208 and 347/600 three phase. No weird *ss tapped or corner ground Delta systems.
There are a few commercial buildings In Toronto etc built in the late 1960's with European 240/416 voltage but North American 60Hz.
The idea was to have just one simplified electrical service in the building. 240V for lights and all office equipment like in Europe. 416V for all three phase motors like Europe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.