Posted by JD Seller on September 05, 2014 at 20:41:02 from (208.126.198.123):
In Reply to: jd 70 question posted by hoosierhog on September 05, 2014 at 19:44:18:
I always hated a JD two banger on a baler tractor. You take the reaction of the pistons in the block and add the baler plunger you make a wagon just about impossible to load easily. It can get to be like riding a ship at sea. LOL
I ALSO HATE HAND clutches for PTO operations. You just run out of hands and feet to run everything.
Put just a little more money with what a JD 70 cost and by a new tractor to hay with or a different brand.
I owned and ran a JD "G" for years. I had to do "real" farm work with it. I HATED that hand clutch. I did not miss that tractor going down the road.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
