Posted by Owen Aaland on September 09, 2014 at 23:42:01 from (216.47.34.49):
In Reply to: electrical question posted by ertl collector on September 09, 2014 at 22:40:32:
Depending on how the wires are connected to the power source what you see as a connection to ground may be the continuity of the wiring going through some other component that is grounded on the other side. Most likely the wires you are checking are connected with a common power source that also feeds other things. With the power on there would be battery voltage going out on all the wires from the common connection. If one of those wires was used to power something like a relay, the relay would close when power was applied. With the power off and you check for continuity to ground from another wire what you will see is the the circuit from the end of the wire with your meter back through the relay to ground. cor circuits like this you need to disconnect both ends of the wire to check for a short to ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
