Posted by Adirondack case guy on September 19, 2014 at 17:40:21 from (74.69.160.79):
Well, I'm done cutting my own wood for the winter to come. I didn't need one of my big loads to finish up. Now in to cutting wood for two of the uncles and the sugarbush. Hopeing for some help on these projects. My attached woodshed holds 17.5 full cord of wood, and it is full to the rafters. It's a good feeling to complete this summers firewood project. The uncles and cousins will rally together to cut the rest of the wood, for their houses and the maple syrup operation. roughly about 35 full cord, more to go. I hit my mark when I cut the last of my wood. Had just a few peices to stack on the boiler tender wagon. It holds a 4X4' square of wood. Lasts about 2-3 days during the winter, when the boiler is running 24-7. As in one pic., you can see that there seams to be a constant source of dieing and dead trees to keep me going. The late afternoon sun shined in on the corner of the shop and woodshed and it spiked the thermometer to 110F and 30min, later it dropped to 50F. I will leave the center door open for a couple of weeks to allow air to circulate through the wood, and it also makes a handy tractor port for my Kubota tractor, HeHe. Loren, the Acg.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
