Posted by TimWafer on October 04, 2014 at 02:33:17 from (70.100.207.40):
In Reply to: Implement rims? posted by rrlund on October 03, 2014 at 06:08:07:
Quoting Removed, click Modern View to see
Actually I had never given this a thought and had used the terms interchangeably, obviously by my first post. I didn’t even realize I had used both terms. Thanks for educating me. I will try to use the correct term in the future.
So to clarify, I’m looking for used 16” wheels with a 6-bolt 6” circle pattern and a 4-5/8” center hole.
The one I saw at auction for $55 was pretty rusty. New ones seem to be $115 or more online plus shipping. That would be in the $500 range for 4.
I wouldn’t be opposed to welding some up and hadn’t considered that before either. Guess I’ll start looking for wheels for that purpose as well. I didn’t think this would be such a challenge to come up with.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
