Posted by PJH on October 05, 2014 at 06:54:42 from (50.40.239.165):
In Reply to: Electrical Wire Nuts posted by DoubleR on October 05, 2014 at 06:16:55:
This has been discussed before.
The first house wiring job that I "assisted" on, the electrician tightly twisted all of the splices and left them conveniently dangling from the boxes. Then he came back with a hot solder pot and dipped a little swivel cup in the hot solder and immersed the twisted wires in the cup of solder. Then he came back and double wrapped the wires with tape, finally meticulously tucking the taped/soldered connections into the boxes. The boxes had to be positioned either on a wall or ceiling/rafter for this to work, of course. He wouldn't allow any of us "helpers" to do the soldering or taping, or tucking. (Maybe that was a statement about what he thought of our work, ha)
I follow the instructions on the box that the wire nuts come in. No twisting. To each his own. I'm glad we aren't still messing around with a hot solder pot and dipper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.