Posted by Texasmark1 on October 08, 2014 at 04:26:38 from (184.20.48.56):
In Reply to: drawbars posted by Mike(NEOhio) on October 07, 2014 at 19:24:23:
Snap to me means tempered steel. It is strong till it gets to it's yield point and then snaps. Mild example is the shear bolt in the PTO shaft of my baler. JD part is a grade 8. JD says that the grade 8 will snap clean and you can get it out where a grade 2 will smear.
Mild steel will slowly bend as you exceed the yield point but will not snap. All in the alloys and tempering (annealing).
I would think that you would want temper to keep it from bending. However, constant pounding especially with spikes above the yield point could shear it.
I saw a connector for a dump truck tag along "Pup" shear right into. The constant pounding of the Pup tongue fatugued the metal and it broke. It was cast however.
I have taken ball bearing races and pounded on them till they crumbled.
I had a drawbar once that needed another hole. I took it to a machine shop and they were able to drill a 1" dia. hole with no apparent problem. Guy didn't charge much and didn't say anything about having to remove temper and re -annealing it.
Just remembered something. Once I hired a neighbor teen and asked him to load some hay on a 16' tandem flat bed. The hitch was on my truck and was not all that thick, maybe cat 2. These trailers have a long distance from the tandem to the hitch as compared to the rear making them tongue heavy.
He loads about 4 high starting in the very front and loads up rather than one full layer at a time. Next thing you know the tongue bends, didn't break just bent.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
