The bottom of the bucket is always set flat on the floor when the loader is removed, and it's flat on the floor now.
There is no pressure in the tractor hydraulic system. The engine is always off when I try to install or remove the loader. I always move the loader joystick to all four positions and hold it in each for a couple of seconds before connecting the fittings.
The nipple in each of the tractor male fittings can be easily pushed in with a fingertip, and no oil comes out when it's pushed in.
It's 11P here in Missouri, and I just tried again and got it. There was pressure in the loader lines.
I was able to push in the nipples in 2 of the female loader fittings and relieve pressure in either the bucket or boom circuit - couldn't tell which because the 4 hoses run in a sheath.
I wasn't strong enough to push in the nipples in the other 2 hoses, and wasn't strong enough to loosen the fittings on the ends of the floppy hoses - there's no possibility I could loosen the fittings.
The solution was a drift with a cupped end against the nipple in the fitting, and 15 or so hits with a hammer. A little oil squirted out each whack and pressure was finally relieved.
When removing the loader in the future, I'll back the tractor away from the loader, then turn off the engine and operate the joystick before unhooking the hoses, same as before connecting them.
Thanks all for the ideas.
Can I be the only guy that's had this problem? One more line in the loader removal section would have been helpful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
