Posted by 2x4 on October 17, 2014 at 20:44:02 from (184.20.127.55):
MF rotary mower has steel pieces around the gearbox that trap water & hold it, about an inch deep. So I wanted to drill holes in these pieces which are about 1 1/2" high & 3/8ths thick so deck doesn't rust thru. I'm on the deck above the drill, drilling sideways thru the steel. Removed my safety glasses so I could see better & drilled in where I'd made the pilot hole; almost thru with the bigger bit when it caught, as they do when the bit is breaking thru. Instead of the drill stopping the bit broke & couple pieces shrapnel from the broken bit hit just below my eye. So fast I couldn't have blinked in time to save the eye from being hit. Guess the moral is to keep glasses on & don't be beside drill bit; be back of it. You never know where the next accident is coming from.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
