Option #1 : 6013 has the softest arc and least penetration. My preference is 5/64 " diameter as they have just enough strength to not flex all over the place like a noodle. If you welder is DC then run the stinger - and the ground clamp +. Otherwise will still work okay on AC. 1/16" diameter is smaller yet but I hate all 1/16" diameter rods except 7014. That said you can cut 1/16" diameters in half to help with the flexing.
Option #2: Use the fast freeze properties of 6011. They do make a 1/16" diameter 6011, but 6011 is a no contact rod and trying to maintain a half a rod diameter rod gap on such a tiny rod diameter that is flexing everywhere can be difficult. Plus 6011 is deep penetrating so move fast. I usually have better luck with 6013.
Option 3: 1/16 diameter 7014 is tolerable of all the 1/16" diameter rods and actually burns pretty decent. That said it may not be able to weld quite as thin as the other 2 choices.
Stick process is not really suited for welding metal thinner than 16 gauge (1/16" thick). Seasoned pros can sometimes do 18 gauge. Regardless you have to be damn goo to weld metal this thin with stick process.
Best choice on metals 26 gauge to 10 gauge is usually a decent mig welder. (and I am not talking those $99 cheapos as those are not worth spit. There are some affordable wire feeders for not all that much more money).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.