Posted by Steve@Advance on November 02, 2014 at 14:52:43 from (107.203.134.67):
In Reply to: Air compressor belt posted by Danofarming on November 02, 2014 at 14:38:20:
Something has probably come loose, like the compressor mount bolts, or the motor adjustment bolts, or the motor pulley has walked on the shaft. If the motor pulley is loose it may have wallowed the bore. If it has it will need to be replaced or it will never stay tight, could damage the motor shaft. Alignment and tightness are critical for those belts.
I use a straight edge, like a framing square, or known straight piece of metal. After checking the compressor mount bolts, lay the straight edge along the outside machined surface of the compressor flywheel. Measure the distance to the edge of the belt to the edge of the straight edge at the flywheel. Compare this measurement at the motor pulley. Adjust the motor pulley until the belt is parallel with the straight edge. Then put the straight edge on the motor pulley. Adjust the motor until the straight edge is parallel with the belt. You'll need to take several measurements and make fine adjustments to get it right.
If the belt has been run misaligned or loose, it may need to be replaced.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
