Posted by WIZZO on November 07, 2014 at 14:36:57 from (31.50.135.247):
In Reply to: Push-Pull plowing posted by WIZZO on November 07, 2014 at 06:24:51:
The concept was invented by Ransomes in Britain and was copied by several other European plow manufacturers.
The principal was to utilize the increasing tractor HP because the rear point lifting capacity was on its limited with 5 mounted furrows. The weight of the front plow added to the traction of the front driving axle aiming at 50:50 weight distribution on front & rear wheels.
In practice it was difficult to steer straight line and balance up front & rear plows furrows. A nightmare to drive through gateways onto roads and along narrow roads with car traffic. They need large flat fields, preferably in one block with no public roads to travel on.
Most plows are now vari-width with furrows adjustable hydraulicly from 12 to 20 inches wide so the load can be reduced to suit the soil type; and with deep digger bodies surface trash can be buried.
The idea never took off in vast numbers of sales, and only Overum in Sweden who purchased Ransomes sell them to-day.
The ever increasing HP & tractor sizes now use semi-mounted plows and even ones with articulated frames.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.