Posted by George Marsh on November 09, 2014 at 13:25:47 from (173.85.211.224):
In Reply to: farmall c with 123 posted by anthem on November 09, 2014 at 12:50:28:
I too have a 1950 C. Because you said it has no water pump, it's a good bet you have one of the first C's. Otherwise the newer one would have a pump. Does it really matter that much what year tractor your have other than having a few more hp and a water pump?
I had to remove the head antifreeze would leak down the side of the engine.
The sleeves on mine stuck about .10 inches above the block. The old mechanic at the IH/case said that was normal. I thought it was very odd. I used loads of copper spray on my gasket and head. I checked, head and block weren't warped.
I had to remove valve train 6 times to re-torque before bolts stopped getting lose, most likely because of the sleeves sticking above block.
That said, if I were you, I would remove the head, get a new gasket, get hi temp RTV and coat the head. Not the ring seal that comes in contact with the sleeve.
It won't be the first time someone thinks I'm crazy, but in the early 70's a college friend had a similar issue with his 4 cylinder ford. Dealer replaced head gasket 2 times and when it went out of warranty, it leaked again. I helped him remove the head, he siliconed it and it lasted him over 100k, until he got rid of car.
It's easy to remove head and try silicone. If you still get antifreeze then you have a crack someplace.
Another friend had similar issue, he discovered this block was cracked internally between lower sleaves. Good luck George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
