Posted by Captain Dan on November 17, 2014 at 05:45:22 from (98.224.166.7):
I have had my snapper 1650 for 20 plus years. Decided last year was the year to do a complete restoration including rebuild the motor. Finally getting all the components back together and tried to start it. Appears to be sparking and getting fuel but won't even pop. I pull the plug after cranking a bit and its wet with gas. When I ground the plug to the head bolt and crank it only seems to generate spark for a few cranks then nothing. I tried a different coil and it does the same thing. Check all the wiring and connections and everything appears to be where it should be. Also notice a few times while under full cranking it would kick back. I'm thinking I have a timing issue? I had the rebuild done by a reputable guy. When I called him about helping with the initial start he was swamped. Snow is starting to hit us hard need my snow thrower. Anyone have any advice. Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
