Posted by LOU from Wi. on November 28, 2014 at 16:47:28 from (69.179.9.68):
This is not the first time,nor the last time we will be using a 1/2 reversible drill for a power source. In the process of grinding hamburger, the counter meat grinder gave up the ghost from stripped plastic gears. Now this was not a cheap Saturday night special meat grinder by no means. My daughter had a old hand crank vacuum counter mounted grinder that the vacuum didn't hold. My son removed the handle and attached a 1/2 " reversible drill. I'll tell you, it worked for powering the grinder, did it so darned slick it out did the counter grinder when it was operating. Never seen one work so clean, other than the grinder in the supermarket. Ours pushed out hamburger without stopping to clean the cutters and the meat grinder plate, which we had to do with the counter top model every 5 minutes. I sure wished we could find a grinder with the power and speed the 1/2 inch reversible has in a new grinder,it's highly unlikely in a counter top grinder. Our counter top grinder was an OSTER and not a cheapy,had it for over 20 yrs, and never knew it had plastic gears and wondered why the didn't make the gears out of steel, other than built in obsolescence. Well anyway we don't have room in our kitchen for an industrial grinder on a stand lol.We are going to finish up the deer using our mickey mouse grinder,just don't tell OSHA. It takes 2 hands to hold the grinder and another person to feed the grinder and push the meat into it with the push stick, plus another person holding the cord to unplug it,in case of emergency. I would hate to process a moose thru this setup,but it works for us for now. Thought you might be interested in learning a new trick or get a chuckle from our ingenuity. Regards, LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.