Posted by NY 986 on November 28, 2014 at 18:00:45 from (174.236.4.65):
In Reply to: Re: bean straw oops posted by John A on November 28, 2014 at 15:59:42:
The OP had mentioned he had snow on the field and in many areas of the North so far this fall that has amounted to several inches. The crop most likely has matted to the ground. Under these circumstances from what I have seen raking and flail mowers/choppers will have minimal effect unless he can run into the soil which would be a big issue if rocks are present. If his soils are clay based there will be issues having the soil dry enough to disk without compaction under the windrow. A modern forage harvester with pickup head teeth close together will pull wet material up with minimal problems and the amount will not differ much if the material had just come out of the back of the combine. A cut and blow machine will handle wet material well enough plus a slight breeze will help with the dispersion of the chopped wet material. If the OP does not have access to a forage harvester or farms in an area where they are not found then he will have to figure out an alternative. There are plenty of reasonably priced older machines out there and he can turn right around and resell it when he is done if he so chooses. Such an operation can be done readily this time of year and make use of time that might otherwise be less than valuable for work versus adding another operation or two in the spring. I hope my first response did not come across as a personal attack as that was not my intent. Just wanted to pass along some personnel experience in a brief manner.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.