Posted by Lon Franklin on December 11, 2014 at 11:36:30 from (24.121.199.98):
I am in the long process of restoring my 1947 early Model B John Deere. !947 was the upgrade year for the newer late Model B. My tractor fell in the middle of the production year and therefore is a combination of the both the early and late Model B tractor. Trying to restore this tractor has had it problems. My latest problem is re wiring the electrical system. So here is my problem. The generator is a three brush generator with an "A" (armature) and "F" ( field) posts. The new regulator has three post; "L" (load), "Bat" (battery), and "F" (field). The light switch has three posts for lights, battery and a resistor. My confusion is with the "L" on the regulator and the resistor on the light switch. With this configuration, can anyone help me out with the proper way to wiring the tractor? According to the parts manual all my part numbers are correct.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
