Posted by oldtanker on December 16, 2014 at 15:06:11 from (64.118.3.75):
In Reply to: Tractos to avoid... posted by GVSII on December 16, 2014 at 14:40:19:
Quoting Removed, click Modern View to see
We had a lot of parades when I was a young soldier. About the only one I didn't mind was our boot camp graduation parade. Other than that they were dog and pony shows to make the brass feel good about themselves. Didn't have very many parades the last few years :) and I declined a retirement parade. The worst was in 94 at Ft Riley. Dead heat of summer on the airfield. Standing on that concrete with the sun glaring off it. It was brutal. Was for a division change of command. The out going general talked for a very long time. The incoming commander, bless his heart, got his turn and said it's hot, people are passing out. I'll come to each unit at a later date to talk to you. Pass and Review! He turned out to be a very good common sense commander!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
