If you go with the clamp-on duals, I highly recommend getting the over center binders from Unverferth instead of the all thread with nuts.
It makes it a lot easier to mount the duals when you are working alone. (shamless opportunity to show unverferth clamps on one of my favorite spring time tractor photos)
I have a lot of trouble mounting my axle duals, but mainly just because they are 20.8x42 and as tall as I am and the dual hubs use lug bolts, not lug studs. I bought a few extra lug bolts and cut the heads off, then cut a screw driver slot in the end. I install 2 of them on the hub, then use them as alignment dowels to get the other bolts in. Then use a big screw driver to remove. You say you are going to leave the hubs on the wheels, and just remove/install by sliding the hub onto the axle? That sounds even harder, but I guess it could work. 18.4-38's are a heck of a lot lighter than 20.8-42's.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
