Hi Trevor, I don't know what CRP ground is , but guessing it is some kind of "land set a side" deal the tree huggers promoted. Ploughing in the winter depends on many variables. Like was there snow before cold temps came? Snow will keep the ground under the snow from freezing down very far. Was the field driven on when wet/and before frost. Compacted wet ground seems to freeze hard like cement. When I plough out a old hay stand ,I like to rip the field ,first one way, and then back the other with my old Graham chisel plough. It is really not much more than a heavy cultivator. This cuts the old sod, and when you pull the plough through ,you don't have any trouble with big sod chunks flipping back over, and the field will take very little work to get a nice top for planting. So you could try to chisel a little to get an idea of the depth of the frost. The corn ground I worked over in the pictures yesterday had 1"-2" of frozen dirt. Last Sunday, no frost, and just a greasy, muddy mess. I had to wait for some cold to freeze dry the mud so I could travel on top, and not just slip and spin mud all over. Corn stalks run through the plough better when dry or frozen too. But the head lands had much more frozen dirt, and the plough wanted to ride up out of the ground where the wagons had packed the ends of the rows. You shouldn't have these kind of problems with a hay field, if you can get the plough to go in the ground, you should be good to go. All you can do is try. Bruce
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
