I had crushed nerve roots twice, to my legs and to my upper left side of body (via neck C vertabrae). Both times I waited until the numbness turned to constant pain. At one point my left arm shriveled up. I finally got a laminectomy. Basically just having the bulged part of disk cut out to relieve the pressure against the nerve root. I argued against it and wanted fusion. I told the doc "trimming" the disk made no sense to me. My take was - if the original full size disk failed, then a trimmed-down smaller one with the same stress on it would fail even sooner. The surgeron did it his way. I was back to work in three months and six months later back in the hospital, worse then ever. 2nd time they fused my vertabrae using pieces of my hip bone. That was in 1992. Still holding up and I've done a lot of heavy work since then. With fusion -it took me 6 months to get my braces off and a full year before I could work hard again. Two 2-3 more years before my damaged nerves got better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
