Posted by rrlund on January 14, 2015 at 10:13:01 from (162.250.25.186):
In Reply to: Re: Bull question posted by Al Baker(pumpman) on January 14, 2015 at 09:43:41:
I used to go out on foot to get the cows to milk. Like I said,that's what the boys were doing when they got hit. I got knocked down myself one time. I walked around the corner of the barn and must have startled the bull. He knocked me down before I knew what hit me. Luck for me all I got out of it was a bruise and a torn pair of pants. I was able to roll out of the way when he backed up to hit me again and I got over a gate,but that was the end of him. If he even saw me in the yard after that he'd start bellering and pawing the ground. The next sale day he was out of here. I don't think it takes any more than a shadow to set them off and drive them nuts sometimes. When I go out around these beef cattle,I won't do it on foot unless I'm close enough to get through a fence before a bull can get to me. I take the 4 wheeler or a tractor to check things. If you've never been hit by one,you're a lucky man. I have been and like I said,so have both of the boys. You'll never know how hard their heads are or the power that they have until it happens. It's one heck of a helpless feeling.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
