Posted by Greg1959 on January 26, 2015 at 19:51:41 from (69.176.46.42):
I have a bunch of hog fence panels (48"x 16').
Since it hurts too much squatting down or bending over while picking beans, figured I'd try this experiment.
Come springtime I plan to take one panel and bend it at 90 degrees 6 feet from each end. Kinda like an inverted "U". That would leave me with a 4 foot wide center.
I like White Half-Runner beans. My thinking is....if I plant the beans along the outside edge and inside edge of the inverted "U" shaped trellis is that they will all grow at the same pace until the ones one the outside edges get more sun and grow faster than the beans planted on the inside edges. Thus, the beans on the inside edges should begin to shoot 'runners' trying to search for more light. Therefore, the plants on the inside will grow higher and hopefully cover the top of the 6 foot tall 'trellis'.
The 4 foot wide opening inside the trellis should still give me room to run the tiller to keep weed control down.
I'm thinking this should make picking the beans much easier. Just walk through the tunnel and outside edges and pick the beans without having to do a lot of stooping and bending.
I also plan to use another hog panel, of the same size, only placed perpendicular to the ground....16' long and 48" high.
Then I will weigh the amount of beans produced from both arraignments to see which produces more beans.
I have always planted my half-runners in rows and will do so again this spring. I just hate all the stooping, crawling and bending it takes to pick them.
So, with this experiment, I'm hoping to be able to harvest the same amount(or close to it) of beans as did with just planting in rows. Only, this time, I won't have to stoop, crawl or bend as much.
Anyone tried this or have thoughts/ideas on this scenario?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.