Posted by paul on February 01, 2015 at 21:15:09 from (66.44.132.180):
In Reply to: Educate me on planters posted by picassomcp on February 01, 2015 at 16:35:44:
7000
Finger pickup for corn. (Very rare plate model up here, you don't want.)
Seed meters for beans are better they are sorta a finger pickup for beans; the original bean cups spill out an amount of beans which is ok on 50 acres not as accurate.
I like granular fertilizer, cheaper, easy enough to shovel 100 acres worth or auger into the planter. Liquid can be applied a lot of gallons 2 inches beside the row; or even mor expensive low salt liquid can be spoon fed into the row as a light pop up fertilizer. Do you like to broadcast fertilizer or manure, or do you want to apply a lot,of,p and k with the planter, or,just apply,a little in the row? Me, I like pitting 100-120 lbs 2x2 beside the row of granular.
You don't need row cleaners in conventional till, tho,if it has them you likely will get a tad of use out of them, and more so if you don't work the ground real hard or leave a lot of bean stubble on the top, etc. you don't want a single coulter out front as a row opener, turns out that was a bad idea for around here....
Double disk openers for the row are the real deal, for fertilizer they are more common, tho single disk fert coulter works for liquid feet.
Here in Minnesota always seems an international 4-800 makes a good notill bean drill, not much of a corn planter.
JD 7000 took over the landscape.
These days you are competing with Ukraine and Mexico, jockeys are buying and shipping them to those emerging ag countries by the container load.
Shoup has all the parts you need to rebuild them, and cheaper and faster than the mega dealers of today can get you anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.