Posted by Billy NY on February 13, 2015 at 05:05:02 from (104.228.35.235):
In Reply to: roofs are collapsing posted by Geo-TH,In on February 13, 2015 at 04:49:54:
There should be redundancy in the snow loading or in the design/construction, if its a possibility, or you had best get some or all of that snow off the roof. Trust me when I tell you, especially with the barn I posted some photos of, this is no fun task, that one you had best stand on the truss top chord, or risk going through, given the old perlins.
I'm not up to date or familiar with the existing snow loading and wood framed structure, but in this area, one would be smart to increase the safety margin on the design/construction of most any structure.
The sad thing about this is that when you get significant accumulations, more than likely you have ample time to remove it or at least lessen the load by removing some of it before it turns granular, hardens up and becomes monolithic.
Our old barns survived snow loads as I recall way back when in the early 70's that exceed any accumulations I have seen since, one was mortise and tenon with thick lumber for roof framing, the other a little more modern with what I believe was actual, not nominal lumber,(modern framing lumber). They knew how to build them way back when.
I can't say I could state how it works engineering wise, but I cannot see any poles supporting a pole barn roof, being further driven into the earth around here, way too much resistance, maybe soft ground ? There would have to be a concentrated point load and if that was so, the roof framing will fail first as I see it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
