Gordo, In order to suck air in, you need a place where air can escape. This shop is very well insulated and well enveloped with Tyvec. The overhead doors have what are known here as Artic seals on the outside. I have been a building contractor and have installed lots of heating systems and the rule of thumb is to place heating equipment under windows and on exterior walls. The unit heater in the pic also pushes air across the boiler picking up heat from it and distributing it further back in the shop to the rear where a ceiling fan pushes the warmer air back down to the floor, and then it circulates back to the front where it is reheated. My shop floors range from 56F towards the front to 62F without the benifit of radiant heat, which would have been in there if I knew back in 88, when I built the shop, what I know now. In 89, I took out our old forced air system with home built wood add-on in the main house and installed an oil boiler and retrofitted radiant under floor heat in the main house and subsequent additions that we built on since. Back then I was too busy and the wife was working and wood heat wasn't practical, other than an air tight "Fireplace Extrordinair" that I built centrally in the house. I installed my dad's Royall wood/coal boiler pictured in the shop 3 years ago after his passing, and my retirement. The Royall wood boiler back feeds the oil fired boiler in my basement, but the OB hasn't run in the last 4 years other than to make sure it will, if something happens to me. Loren
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
