I have a bored well that is 83 feet deep. It has a 30 inch Galvanized casing (culvert) which extends 2 or 3 feet above ground with a lid on it.
About 8 feet below ground level, it was trenched from the well to the dwelling.
The casing was drilled to accept a Pitless Adapter at the 8 foot deep mark. The water line runs at this depth for about 120 feet to the Pressure Tank in the basement of the dwelling.
I have a Submersible Pump down at about the 75 foot mark, with 1 1/2 inch black ABS pipe (heavy wall) coming to the Pitless Adapter. From there, lighter wall ABS pipe of the same diameter runs up to the Pressure Tank; the electrical wiring runs in the same trench.
Never any freezing problems (no heat in the well). This is in North/Central Alberta, Canada (where we do get cold weather!).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.