The old wells in our area, Central Iowa, are normally setup like this. Manhole sits close to ground level and is approximately 5ft in diameter and around 6 ft deep. It is encased with block walls or poured concrete or even precast concrete. In this section you will find all the electrical and plumbing connections and pressure tank. Then the bored well starts in here with 6 inch casing however deep to bedrock and then open walls to however deep the well is (180 plus ft.) Water pipes to the hydrants leaves at the bottom of the manhole, so there is no risk of freezing.
My manhole was cold enough to freeze one time since I have lived here, it was really cold and really windy with no snow cover one night and one of the pipes froze, I put a milkhouse heater in there for a couple hours and all was right again. I now make sure the lid is on tight before winter sets in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
