Ya,it's best to go to Board of Review to let us know that a building is gone. You're supposed to get a demolition permit to tear something down,but people almost never do because they think it's an attack on their freedom,but it's actually just to let the assessor know that the building is gone. Here in Michigan,you actually pay taxes on what you had the previous year. Like I said,December 31st is the day that assessments are based on. The new notices went out last week based on what was on the property on December 31 2014. Board of Review meets for protests the second week of March. School taxes are due in September,notices for winter taxes go out December 1st and you will have until February 14th 2016 to pay them if you choose to wait that long. As far as giving somebody a break,we gave in once. We had somebody come in,spitting and drooling,telling us the house in question was uninhabitable. We told him,OK,have it down by the July Board meeting and we'll take it off. He didn't. It's gone now and we took it off,but even giving him extra time didn't prompt him to get it done. Personally,I think taxing people a year late is a big enough break. They pay 2014 taxes in 2015 or 2016 and if they remove something in 2015,they won't pay 2015 taxes on it in 2016 or 2017,should they choose to wait until February 2017 to pay those taxes. If I remember right,Tractormiallis lives just over west of me right here in Michigan,so what I'm telling you applies to his situation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
