Posted by Loren in MN on March 02, 2015 at 17:56:52 from (184.100.97.155):
In Reply to: ih 2000 loader posted by Brian806 on March 02, 2015 at 15:10:12:
I have a 756 with the 2001 loader, same frame as yours. If needed, I can get you picts of my mounts. The loader was meant to be mounted on a Farmall 460 or a 504. I have approx 12 inches of a 5x6 iron tube mounted to the front of the axle with long threaded rod/bolts on top/bottom with a heavy flat iron bent around the rear diamond of the axle, then the frame of the loader is bolted to the front of the 5x6 tube(placed verticle) at front side of axle. The tube is your spacer -hope this makes sense. My loader had the original front side frame mounts that are simple irons bolted to the engine frame rails with the loader frame resting on top of these irons. Front side mounts are not bolted to the loader frame.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
