Posted by wjkrostek on March 08, 2015 at 13:34:28 from (216.152.179.128):
I think you must be confusing degrees with % slope. 20 degrees is 36% or 1:2.75; 40 degrees is almost 1:1 and you say a" mildly steep" I think 20 degrees has to be about the most slope anyone should be on with tractor. Unless like one said if you pack up and come stright down. Get a long 2x4 a level and a tape and see what kind of slope you really have. Your center of gravity on your tractor will be somewhere between you PTO shaft and your seat. Once that center of gravity get to the out side tire she is over and there is nothing you can do but go over with her. Good luck.
shortyedwards said: (quoted from post at 10:40:15 08/12/13) Hi all - I recently purchased a 1940 Farmall A. In my wanderings around the web looking for info. I'm seeing more and more about how easy it is for these old tractors to flip and tip. Part of my property (and the reason I bought this tractor) is on a mildly steep grade (say 20-40 degree slope)and it needs to be bush hogged. Should I not use this tractor for this purpose? Not being experienced can only make this a bigger problem and I don't want to get hurt. Should I be using a garden tractor with a lower footprint of lower center of gravity? Perhaps I have purchased the wrong tractor for my uses.
I'm open to your opinions. I haven't purchased the bush hog yet and won't be doing so until the spring. Or I may just unload this piece and put it towards a newer tractor. Let the discussion begin, and I do appreciate it.
-shortyedwards
This post was edited by wjkrostek at 13:47:01 03/08/15 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.