Posted by KEH on March 11, 2015 at 06:01:29 from (67.231.175.190):
In Reply to: 223 ammo posted by jeffcat on March 10, 2015 at 19:41:39:
A bullet penetrates because of weight, velocity, and bullet construction, with velocity being the most important. I don't know how much material the .223 ammunition is supposed to penetrate, but here are some earlier figures: The Civil War muzzleloader, .58 caliber, was supposed to penetrate 12 inches of pine wood and it had a very heavy lead bullet fired at maybe 1200 feet per second. The 30-06 army cartridge, ball ammunition not armor piercing, was supposed to penetrate 1/2 inch of mild steel and was fired at about 2800 feet per second depending on which weight of bullet was used. There is army body armor that will withstand that, but it is heavy and involves use of a steel plate. The 30 caliber armor piercing bullet was supposed to penetrate 1/2 inch of armor plate.I don't know how much a military 223 is supposed to penetrate, but I doubt if it's more than this.
A cast lead bullet can be fired in .30 rifles at up to about 2000 feet per second with hunting accuracy. Faster than that an the accuracy falls off badly due to air friction melting the bullet. The lead bullet will penetrate at least 1/4 inch of steel at the faster velocities. Would this penetrate a bullet proof vest? Don't know and have no plans for experimenting due to costs of vest.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
