Posted by Bret4207 on March 16, 2015 at 03:57:52 from (64.19.90.196):
In Reply to: 223 ammo posted by oldtanker on March 15, 2015 at 10:38:15:
Quoting Removed, click Modern View to see
Well, first off no one is shooting naked, pure lead cast bullets over the 1800 fps area. As far as seams showing, I'm assuming you mean casting quality and you're right again, to an extent. The seam is going to show to a greater or lesser extent assuming someone doesn't "pretty" their bullets up by tumbling or giving then a swipe with 4/0 steel wool. A micrometer will give you the real story. But yeah, all the little variables get more and more pronounced the harder you push them. Too many people have bought a box of commercial cast over the years and stuffed them into a case using the same care they'd use with jacketed with the same load and shot them down a fouled barrel and decided cast was junk. They just didn't know the first steps. If there's one thing the internet has done, it's freed us from 100 years of old wives tales and typewriter commando "facts" that have been repeated over and over, many in the major shooting publications.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
