I myself seam to buy tractors and equipment that seam nobody wants or think its to far gone to keep and let it go. I buy it and fix them back up to good condition and working order. I take pride in making something from nothing and back in the field. The older stuff is easy enough to work on and get parts for. Now this new stuff now in 25 years may not be running simply because you just don't know if the computer and operating system will be supported after say 15 years. Case in point JD 9400 combine, If the computer dies and if you can find a used one to get it going your in good shape but no new ones are made now. Outdated and old so junk it because it wont run without it. Last year I bought a 1555 Oliver (ware it was sitting for 3 years in picture) for parts to use on my 3 1550's I have. I got it home and did a hard look at it, Record radiator new intake exhaust manifold 2 year old clutch pressure plate and throw out bearing and strait sheet metal. The bad, engine locked up 3 bad tires bad seat faded paint and missing some small parts hear and there. I could not part it out till I tried to get it running. Well I did and fixed her up and sold it and made alittle money and bought parts to fix the other 1550's I have. I took pride in the fact that I got her looking good and back in the field. The man the has it now loves it and knows what I did to it. I'm in my 50's and I figure I will keep doing this till the day I die, So your in the same boat as me and a lot of others so keep up the good work and doing what your doing. Bandit
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.