Posted by Banditfarmer on March 26, 2015 at 06:52:41 from (75.186.9.25):
In Reply to: Soybeans posted by DeltaRed on March 25, 2015 at 21:50:10:
Steve being that you will be doing irrigation you will need a bushy soybean to plant in 30" rows so they will fill out and shade the ground, This will help hold moisture in the ground and help keep weeds under control. Now the planter plates you will need are the B2 or B3 plastic plates. Myself I would go with the B3 plates and hears why. A B2 plate is a 24 cell plate that will fit 4 bean seeds per cell, Now the B3 plate is a 32 cell plate that will fit 2 bean seeds per cell. Both will work fine but the B3 plates will give you more uniform seed spacing and that's what it all about. I thing I will tell you is that when you look at you book for the JD 71 units they were set up in pounds of seed per acre. Todays seed is most of the time small seed, Bags use to be sold as 60# bag or a bushel and now are sold as a unit of population per bag and the weight and seed size can very greatly. Sometimes a bag of seed will weigh 41# and the seed is small and sometimes the same population beg of seed will weigh 56# and the seed is bigger, So it a crap shoot year to year for us guys using old plate type planters to plant with. That is why I would go with the B3 plates because of the smaller cell size and more uniform seed spacing.
The picture is a AC 16 cell planter plate a JD B2 24 cell plate and a JD B3 32 cell plate. The AC will have 6 beans per cell and the B2 will fit 4 beans per cell and the B3 will fit 2 beans per cell. I hope this helps. Bandit
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
